Guard Roll Forming Machine XF192

 Guard Roll Forming Machine XF192

 

Product Description

XF192 Guard roll forming machine 

1. Brief introduction: 

A. Simple structure and beautiful outlook; 

B. Easy to setting and operation 

C. Little noise and high working efficiency. 

2. Main technology parameter: 

 Roll forming machine

The structure of equipment 

1. Hydraulic decoiler  roll former

Single unrolling machine, one side can put material 

Adopt automatic hydraulic system 

Coil weight (Max): 7000kg 

Coil dia (Max): 1600mm 

Oil cylinder dia: 1200mm working pressure: 10mpa 

Coil Width(Max. ): 500mm 

  forming machine 

2. Feeding, leveling 

Feed into unit oriented wheel(can right and left adjust) 

Into feeding roller, dia is ¢ 180mm, material 45# steel, quenched 48-52, chromed 

Leveling is three roller above and four roller below, quenched and chromed 

 

3. Punching (can right and left adjust) 

Using hydraulic punching 

Oil cylinder dia: 140mm 

Working pressure: 20mpa  roll forming

Mould material: Cr12 quenched 58-62 

Hydraulic power: 7.5kw 

Size: 1.5m long*1.1m wide*1.2m high 

 

4. Roll forming 

Main motor power: 45kw 

Decelerating motor: BWD14-43-37kw, made in Shanghai or 

Changzhou 

Drive: Gimbal driving, 120*500 

Main shaft dia: 100mm material: 45#forge steel 

Roller material: GCR15 quenched 58-62, chromed 

Roll station: 17stations 

Timing by transducer: 5m--20m/min(not including punching) 

Transducer: Panasonic made in Japan. 380V 50Hz 

Computer: PLC 

Computer operating panel: Touching screen 

 

5. Cutting 

Hydraulic cut 

Knife material: Cr12, quenched 58-62 

Oil cylinder dia: 250mm 

Working pressure: 30mpa 

Working journey: 80mm 

 

6. The Outside size: 

18m long*2.2m wide*1.5m high 

 

7. Run out table 

Jointed by 60mm*40mm tube (can be adjusted to up and down) 

Size: 1.5mlong*0.8mwide*0.6-1mhigh(can be adjusted) 

The parts of machine 

Hydraulic passive Uncoiled, Forming Machine ( feeding, leveler, roll mill, cutting, punching, PLC computer, Hydraulic station, cutting), and simple run out shelves 3PCS, packing list 1 PCS. 

 

8. The production flow of equipment 

Decoiling_Feeding(take the sheet to the first station)_leveling----Punching of the sheet _roll forming----hydraulic cut to length-product packing manual.