Auto-pressure wet pressing production of glazed tile machine is used to vacuum when the screw extruder after the extrusion and cutting of rough tile blank precise shape of hydraulic pressure to suppress tile machine. Automatic pressure pressure-watt machine can be installed separately to use, but need to manually install billet, billet unloading can configure automatic loading and unloading aircraft billet mechanical hand with the extruder, cut tile pressing machine, send blank machines and conveyor lines Vaahto Roll forming machine Group into a blank tile production line, all without manual operation. This machine mainly by the left and right body, the bottom of the connecting rod, the top chassis cover, sliding seat, six-wheel, pulley, gear mechanism, geneva mechanism, cam mechanism, lubrication pumps, hydraulic system, electric control part of the peer group Cheng. The aircraft on the die stamping processes: from motor through the pulley to drive the input shaft, through a small gear, large gear to drive the shaft, through a cam drive with a sliding seat up and down on the die movement, to achieve pressure watts. The transposition table is mounted on the shaft head gear group, transmission gear sales call, toggle wheel shaft installed in the six-party slot wheel to achieve sub-degree position, in the last two ends of each shaft is equipped with a mounted on the same axis with the suppression of the conjugate cam cam-back, through the positioning rod and positioning plate under the mold in the work place to achieve the precise positioning. In the left and right chassis, equipped with lubrication pumps, machine work, pass through the pipeline transport oil to the rubbing parts. 
    Roll forming machine Automatic pressure-watt machine table with six processes, bench flip, unless there are a mechanical indexing, positioning, it also set up a set of precise positioning body, is exclusively to ensure that every time stamping process, the accurate positioning table mold installed on the die slide tower was the case structure, slide sets and the body guide rails, contact length of the large, on every stamping die, stamping processes about two pairs of Ni Pi-mode for the first time that the pressure on the blank tiles in place After the model increased by 10 mm, so that the full exhaust Nipi, after further downward pressure on the mold blank tile in place before I return to the highest position, and therefore die long life, to suppress the product of good quality. Tile machine will automatically configure a set of pressure lubrication system, the machine running automatically on all load bearing, transmission gears and other parts of body movement for rail lubrication.