Double-layer pressure-watt machine debugging method 

      1, first double-layer pressure-watt machine before and after the two-line stand in the end the four corners of the shaft from the side of a large quantity of the same height, and then discharged to the last row from the first to find a line to straighten, check the next axis whether in a straight line, the lower shaft left and right sides horizontal transfer. Roll forming machine 

      2, the double-layer pressure-watt machine in the first row and last row to find a good center, and then tighten the lock on both sides of the mother, in the middle rounds in the center before and after the lay a straight line, the upper and lower gap adjust shaft After the machine can be adjusted along the line. 

      3, double-layer pressure tile machine plate deviation debugging methods, such as the right running board, pad left corner (into the rack), or down the right side of the bottom level (the first of several axis deviation axis almost failing the bottom level, on axis with the the whereabouts of the end of shaft)